 |
RUBBER LAGGINGS
Prevents light loads from slipping and protects the
surface of loads during transfer. Rubber is molded
(vulcanized) on to tube to assure permanent adhesion. |
 |
BUILT-IN BRAKE
Eliminate load inertia and enable precise stopping.
Electromagnetic brake is engaged by spring force when
power to the motor is interrupted. Minimum tube length
is 250mm (10") and -One-touch- mechanism is included
with tube lengths of 300mm (12") or more. Maximum
Continuous energized time is 30 minutes with a 70% duty
cycle. |
 |
FREE CLUTCH
* When power is on, Power Moller® functions normally.
* When power is off, Power Moller® functions as an idler
roller.
* Available for PM570AS/PM605AS series models.
* The minimum tube length that Free Clutch option can be
attached to is 11". In case the Power Moller® has a
spring-loaded end cap, the said minimum length is 13".
* Free Clutch option can be added to the Power Moller®
with
brake. In this case, the minimum tube lengths are 13"
without
a spring-loaded end cap and 15" with a spring-loaded end
cap. |
 |
WATERPROOF
Designed for outdoor lines or lines subject to water
spray (washdown).
Output and attaching shafts, end caps and tubes are made
of stainless steel to resist corrosion. Waterproof
specification IP-65, IEC 529.
* Direct Water Spray to Shafts in Washdown Application
may reduce life
power of Moller.
* Waterproof Option may affect speed and torque.
* Contact Itoh Denki for speeds available. |
 |
DRIP PROOF
Used on conveyor lines that are located in areas with
high moisture levels.
Attaching shaft and shaft caps are made of stainless
steel to resist corrosion. Drip Proof specification
IP-55, IEC 529. |
 |
DUST PROOF
Used in dusty or powdery environments. Rubber seals
protect the POWER MOLLER® bearings from contamination.
|
 |
CLEAN ROOM
Designed for the handling line that requires a high
degree of cleanliness, such as in the electronics, food
and pharmaceuticals industries etc. Includes the
features incorporated in the drip proof option as well
as standard leadwires and stainless steel tube,
attaching and output shafts. |
 |
BELT PULLEY AND GROOVES
POWER MOLLER® and corresponding idler rollers are
available with a special end cap or grooves to
accommodate small V-belts or round belts. The POWER
MOLLER® can be linked to idler rollers on light
load/small size applications where consecutive -live•
rollers are required. Minimum tube length is 250mm (10")
-One Touch• attaching shaft is standard for all tube
lengths. |
